Micro sd card extension mount
by IronTurbo86
28
Downloads
24
Likes
1
Makes
++UPDATE++ i added a new file for the same mount but the hole is for an m5 bolt and t-nut as requested.
use an m4 bolt and T nut for the front to better secure it to the extrusion. flip 90 degrees and print on its side with tree supports. if the supports arent supporting in where the sd card reader slides in thats not an issue as that isnt a very long gap to bridge...and if i can bridge it with petg with little issue im sure anyone can.
post processing is minimal to zero pending how well your machine bridges. i had one or 2 stray filament lines inside the sd card reader pocket.
use an m4 bolt and T nut for the front to better secure it to the extrusion. flip 90 degrees and print on its side with tree supports. if the supports arent supporting in where the sd card reader slides in thats not an issue as that isnt a very long gap to bridge...and if i can bridge it with petg with little issue im sure anyone can.
post processing is minimal to zero pending how well your machine bridges. i had one or 2 stray filament lines inside the sd card reader pocket.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
