Thingiverse
Micro SD Card Keyring Holder
von KaytyMoo
0
Downloads
3
Likes
0
Makes
This uses your key ring as the pin to hold a singular micro SD card, It needs to be printed upright as it would be near impossible to get the supports out horizontally,
This would not work as a standalone part, You need a keyring/clip of some sort to hold the card in securely, it has a little window so if it did get stuck you could leverage it out, I haven't had any issues but it's a nice safety.
I printed this 0.2 layer height with 100% infill, You probably want a brim unless you *really* trust your printer, You *could* go bigger with the layers but because the design is printed vertically, you want the best layer adheasion you can get, because it's such a small part it's pretty strong and I trust it with my SD cards. *(I did make it so maybe I'm biased)*
This would not work as a standalone part, You need a keyring/clip of some sort to hold the card in securely, it has a little window so if it did get stuck you could leverage it out, I haven't had any issues but it's a nice safety.
I printed this 0.2 layer height with 100% infill, You probably want a brim unless you *really* trust your printer, You *could* go bigger with the layers but because the design is printed vertically, you want the best layer adheasion you can get, because it's such a small part it's pretty strong and I trust it with my SD cards. *(I did make it so maybe I'm biased)*
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!