Micro SD card remover

I have fat fingers. Do you?
I made this to remove microSD cards from tight holders.
Doesn't need to be super-strong, so PLA, PETG, ABS should all work.
Print laying down flat.
I would print in 100% infill, with the thinnest layers your printer will provide.
I did not use supports between the sides of the prongs, so you will have to trim out a little bit where the edge of the card goes. I felt that if I put in supports, I'd just have to dig those out anyway.
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/857S3omAiQu