Thingiverse
Micro SD to SD card adapter bracket
di jimb15122
13
Download
10
Likes
1
Makes
This bracket attaches a micro sd to sd adapter to the Ender 3 PRO frame. Intended for use with adapters that use a shorter 15 cm cable length, as shown in photo, but design is fairly universal and could be used in other scenarios.
Search for "15CM Micro SD to SD Card Male to Female Extension Cable Adapter".
If you do a lot of SD card based printing, then this is a must have upgrade. Full sized SD cards are much easier to handle, sturdier, and harder to misplace.
Requires 2 short m4 or m3 screws and 2 T nuts to attach.
Note: After taking the photo, I discovered that sliding the bracket as far forward as possible improves handling ergonomics significantly.
Search for "15CM Micro SD to SD Card Male to Female Extension Cable Adapter".
If you do a lot of SD card based printing, then this is a must have upgrade. Full sized SD cards are much easier to handle, sturdier, and harder to misplace.
Requires 2 short m4 or m3 screws and 2 T nuts to attach.
Note: After taking the photo, I discovered that sliding the bracket as far forward as possible improves handling ergonomics significantly.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
