Thingiverse
Micro Spray riser
door Kaptan_GAK
5
Downloads
7
Likes
0
Makes
This is a Micro Spray riser for a 6mm pipe. depending on the quality of the print you may need to clean out the hole.
Just simply push the 6mm pipe through the hole (wiggle and turning helps) with 15 - 20 mm out the other end. Attach the micro sprayer and pull the extra pipe back, place where required.
Just simply push the 6mm pipe through the hole (wiggle and turning helps) with 15 - 20 mm out the other end. Attach the micro sprayer and pull the extra pipe back, place where required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!