Micro Swiss Direct Drive

Bracket to support the cables for a Micro Swiss Direct drive and all metal hot end conversion.

I have installed the all metal hot end and direct drive to my Ender 5+, but there was no where to mount the cables.

There is however 2x screw holes on the main back plate that are not used, so I designed this bracket to sit on the corner plate and mount to the direct drive back plate.

The Image of the STL above is upside-down, so when you print it, rotate it so the flat side is on the print bed.

Other parts i have designed this to work with are:
The X axis gantry cable holder here:
https://www.thingiverse.com/thing:5189350

the Rear right upright bracket here:
https://www.thingiverse.com/thing:4796135