Thingiverse
Micro USB Cord Plug
von captainserious
80
Downloads
74
Likes
0
Makes
The housing around the end of one of my USB cords broke. The cord still worked to charge the device even though the housing was missing so I decided to print a replacement.
The printed housing has a feature that fits into the groove in the molded strain relief. Otherwise, the entire plug is just glued into the printed housing with hot glue. After the wiring is secured, the top cover is glued on, again with hot glue.
The printed housing has a feature that fits into the groove in the molded strain relief. Otherwise, the entire plug is just glued into the printed housing with hot glue. After the wiring is secured, the top cover is glued on, again with hot glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!