Thingiverse
Micro USB plug enclosure
von Lucaspwo
32
Downloads
43
Likes
0
Makes
Protective shell I made for a Motorola (Moto Maxx / Droid Turbo) micro USB plug. After all these years the original protective rubber dried and fell off, leaving its metal interior exposed.
The parts were glued together with super glue.
I recommend printing with the hollow interior upside down, while using supports. The fillets are printed better this way.
The parts were glued together with super glue.
I recommend printing with the hollow interior upside down, while using supports. The fillets are printed better this way.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
