Microchip MPLAB SNAP R2 cover

Microchip MPLAB SNAP R2 programmer enclosure + pinout sticker The case fits the new R2 version of SNAP programmer that has the additional jumper for AVR/PIC selection. I have designed the enclosure to be as simple as possible. Its two peace's that snap together with no postprocessing needed after print. The AVR/PIC Jumper can be changed with a help of small tweezers! 3D print notes:Any material can be used but its essential that the material has a good layer/layer adhesion, so the snap wings don't brake off. BambuLab PLA filaments are a good choice0.4mm nozzle was used for the print with 0.16mm layer height and 2 wall loops Assemblly:Just put the MPLAB SNAP programmer completely with feet into the bottom part of the printSnap the cover onto itPrint the sticker and cut at the dashed lineFor the jumper hole cutout use an exacto knife Remix notes: Made this remix primary from the nice pinout sticker work of “Sparky Summer”. The sticker is an evolution of the original author that f