Thingiverse
Micromake D1 Z-Probe
von grappyX
9
Downloads
5
Likes
0
Makes
Z probe - to produce good results through an automatic leveling (no force on the limit switch)
Use - original switch & 2xM3 screws...
Don't forget to change the endstop from normaly closed to normaly opend.
This desing was made so you have no X/Y - offset of your z-probe.
Fits perfectly on the original affector from the Micromake D1 Delta printer.
After calibrating add 17,5mm to your Z-Height.
Use - original switch & 2xM3 screws...
Don't forget to change the endstop from normaly closed to normaly opend.
This desing was made so you have no X/Y - offset of your z-probe.
Fits perfectly on the original affector from the Micromake D1 Delta printer.
After calibrating add 17,5mm to your Z-Height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!