Thingiverse
Micromount Sample Carrier
door ntdesign
11
Downloads
13
Likes
0
Makes
A carrier for 5 magnetic micro mounts. The lid snaps in place, if needed it can additionally be secured with zip-ties or rubber bands. Very handy to transport or send samples to other labs.
There is enough tolerance to print this at higher speed / lower quality. The print in the foto was done with 0.2mm, 50mm/sec, 20% infill.
Make sure to rotate the lid for printing, so the top is facing down (sorry for that, I lost the design file).
There is enough tolerance to print this at higher speed / lower quality. The print in the foto was done with 0.2mm, 50mm/sec, 20% infill.
Make sure to rotate the lid for printing, so the top is facing down (sorry for that, I lost the design file).
ntdesign publiceert ook op
144 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!