Thingiverse
Music
Model downloaden
Microphone & cable support
3
Downloads
5
Likes
0
Makes
Just a mike holder I designed for my daughter's karaoke speaker (the mike was always around).
The conical holder is attached to a couple supports that can double as cable holder. Wrap the cord around it and insert the jack in the middle.
I designed it so that it could be used with any standard microphone.
If you need steady support, just drill some holes for screws on the base. I used superglue to stick it to the speaker and it did the job.
The conical holder is attached to a couple supports that can double as cable holder. Wrap the cord around it and insert the jack in the middle.
I designed it so that it could be used with any standard microphone.
If you need steady support, just drill some holes for screws on the base. I used superglue to stick it to the speaker and it did the job.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
