Thingiverse
Microphone anti-shock stand
door FooRider
54
Downloads
42
Likes
0
Makes
Anti-shock stand for Yeti microphone by Blue designs.
A friend of mine complained that his mic registers vibration from his keyboard (located on the same desk), so I went on to make this to isolate the mic from the desk.
I printed it on Prusa i3 MK2S, 0.2mm layer height with PLA.
The rubber legs are anti-vibration stands that I got laying around. I used springs I bought in a set at my local store, I have no idea about their specs. But it's not important that the legs are made from rubber, as the anti-shock function is primarily achieved by springs. You can print any cylinder to replace them, though I'd suggest an anti-slipping sticker on bottom.
The thing ended up better than expected, the mic is suspended about 3 mm above desk. But this height can be further lifted by using washers between the rubber stands and base part.
A friend of mine complained that his mic registers vibration from his keyboard (located on the same desk), so I went on to make this to isolate the mic from the desk.
I printed it on Prusa i3 MK2S, 0.2mm layer height with PLA.
The rubber legs are anti-vibration stands that I got laying around. I used springs I bought in a set at my local store, I have no idea about their specs. But it's not important that the legs are made from rubber, as the anti-shock function is primarily achieved by springs. You can print any cylinder to replace them, though I'd suggest an anti-slipping sticker on bottom.
The thing ended up better than expected, the mic is suspended about 3 mm above desk. But this height can be further lifted by using washers between the rubber stands and base part.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!