Thingiverse
Microphone boom arm table bushing
by rtarb
0
Downloads
0
Likes
0
Makes
Needed a table bushing for an OC White boom arm, found out they charge $72 each for them, so I made my own.
This will also work for any boom arm that has a 13mm peg on the end. This also works for my Warm Audio WA-MBA arm.
Supports are needed for the bushing. I printed mine with the flat side down. Getting the support material out of the hole can tricky but is possible.
This will also work for any boom arm that has a 13mm peg on the end. This also works for my Warm Audio WA-MBA arm.
Supports are needed for the bushing. I printed mine with the flat side down. Getting the support material out of the hole can tricky but is possible.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
