Thingiverse
Gadgets
Ver Modelo
Microphone Desk Boom
177
Descargas
169
Likes
0
Makes
This is an almost fully printable microphone desk boom. The non printed hardware needed is:
•2X Hex Head Screw 1/4"-20 Thread Size, 1-1/2" Long (7/16" Hex)
•2X Nylon-Insert Locknut 1/4"-20 Thread Size (7/16" Hex)
I ended up not using the screw caps and instead used real tools to tighten the bolts as it was too difficult by hand.
To assemble:
1) Insert post into clamp and secure with post key.
2) Press fit post extender into the first post if additional height is desired
3) Assemble the rest of the setup according to the provided pictures
•2X Hex Head Screw 1/4"-20 Thread Size, 1-1/2" Long (7/16" Hex)
•2X Nylon-Insert Locknut 1/4"-20 Thread Size (7/16" Hex)
I ended up not using the screw caps and instead used real tools to tighten the bolts as it was too difficult by hand.
To assemble:
1) Insert post into clamp and secure with post key.
2) Press fit post extender into the first post if additional height is desired
3) Assemble the rest of the setup according to the provided pictures
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
