Thingiverse
Music
Model downloaden
Microphone stand small table adapter
6
Downloads
4
Likes
0
Makes
In order to make supports for a mobile (and light) multichannel system, I designed this simple adapter.
To be fixed on a wooden plate of 20x20x1cm with 4 screws or bolts M3. Drill a 0,8cm hole in the middle (space for the foot screw, otherwise it won't fit completely).
The 1.5cm model should fit most microphone stands, especially K&M models. (15_Mic_stand_tablet_2.stl)
1,2cm one is designed for a smaller mic stand, but I didn't need it nor print it.
It can take a load of 1-2 kilos. I use it for the JBL control ONE pro.
To be fixed on a wooden plate of 20x20x1cm with 4 screws or bolts M3. Drill a 0,8cm hole in the middle (space for the foot screw, otherwise it won't fit completely).
The 1.5cm model should fit most microphone stands, especially K&M models. (15_Mic_stand_tablet_2.stl)
1,2cm one is designed for a smaller mic stand, but I didn't need it nor print it.
It can take a load of 1-2 kilos. I use it for the JBL control ONE pro.
Lebkuchen publiceert ook op
28 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
