Thingiverse
Music
Ver Modelo
Microphone Vibe Mount
37
Descargas
30
Likes
0
Makes
A friend needed a suspended mount for his microphone but since I didn't really liked the existing designs I made my own. :)
The idea is really simple. The mike is held in the middle using cross-mounted rubber bands. The knob is mounted on the mike stand. The inside diameter of the cylinder is 100mm.
The printed version shown in the pictures is an earlier variant but the basic dimensions is the same. I've printed it with both 20% and 40% infill and both feels sturdy and reliable.
As always, if you find it useful a tiny donation goes a long way to show appreciation. :)
UPDATE 2018-03-08: Made a revision (rev2) with some holes to speed up the print and use less filament.
The idea is really simple. The mike is held in the middle using cross-mounted rubber bands. The knob is mounted on the mike stand. The inside diameter of the cylinder is 100mm.
The printed version shown in the pictures is an earlier variant but the basic dimensions is the same. I've printed it with both 20% and 40% infill and both feels sturdy and reliable.
As always, if you find it useful a tiny donation goes a long way to show appreciation. :)
UPDATE 2018-03-08: Made a revision (rev2) with some holes to speed up the print and use less filament.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
