Thingiverse
Microquad 65mm Smiley
von KevinKuwata
14
Downloads
9
Likes
0
Makes
Created a solid frame for F3 Evo board from bang good. Uses a combination of pressfits to mount the camera, the motors, and the flight controller.
Can uses 55mm or 65mm props. Designed for 65mm and is about 64g total weight with a 720mah battery.
Utilize rubber bands (dental bands) for holding battery in place.
Tight fit for motor mounts to prevent wires from being removed from the base of the motors.
The previous version of this where the frame was 2 grams lighter, did not increase performance enough to justify the constant breaking of motor wires.
The camera mount and camera info can be found here: http://www.thingiverse.com/thing:1734830
Can uses 55mm or 65mm props. Designed for 65mm and is about 64g total weight with a 720mah battery.
Utilize rubber bands (dental bands) for holding battery in place.
Tight fit for motor mounts to prevent wires from being removed from the base of the motors.
The previous version of this where the frame was 2 grams lighter, did not increase performance enough to justify the constant breaking of motor wires.
The camera mount and camera info can be found here: http://www.thingiverse.com/thing:1734830
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!