Microscope Bolt On Lamp
par Blablabliam
1
Téléchargements
2
Likes
0
Makes
This is a DIY Bolt-On Lamp for microscopes. This uses three LEDs and a potentiometer to illuminate the top of a slide. The print is bolted to the microscope neck, so that the LEDs point down onto the slide.
Parts:
Resistor
Potentiometer
Barrel Jack
3 LEDs
2 M4 Bolts and Matching Nuts
4 Screws
The circuit schematic is up to you, since you can use any three LED's you want. I will be printing one for white, RGB, and UV so that I can illuminate with any part of the spectrum.
The potentiometer allows for some adjustment of the brightness, but always be careful and never look into a microscope if you think the light is strong enough to hurt you.
Parts:
Resistor
Potentiometer
Barrel Jack
3 LEDs
2 M4 Bolts and Matching Nuts
4 Screws
The circuit schematic is up to you, since you can use any three LED's you want. I will be printing one for white, RGB, and UV so that I can illuminate with any part of the spectrum.
The potentiometer allows for some adjustment of the brightness, but always be careful and never look into a microscope if you think the light is strong enough to hurt you.
Blablabliam publie également sur
39 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !