Thingiverse
MicroSD Card Holder with Note
door mike_e_allen
2
Downloads
0
Likes
0
Makes
Holder for 1 MicroSD Card with a note.
Took inspiration from a couple of other designs and made some adjustments.
There should be no need for supports. I print this with 5% infill, as there is not much strength needed for the print.
The cutout on the holder is 11mm, and the space underneath on the tray is 12mm. I use this to print a 1/2inch Brothers label and stick it to the tray, the cutout on the window then slightly captures the top and bottom edges to help prevent accidental lose.
A microsd card should snap into the card cutout with ease, and then you can use your nail to lift it back out.
The holder should snap snuggly into the tray. It can be lifted out with the tab if needed.
Took inspiration from a couple of other designs and made some adjustments.
There should be no need for supports. I print this with 5% infill, as there is not much strength needed for the print.
The cutout on the holder is 11mm, and the space underneath on the tray is 12mm. I use this to print a 1/2inch Brothers label and stick it to the tray, the cutout on the window then slightly captures the top and bottom edges to help prevent accidental lose.
A microsd card should snap into the card cutout with ease, and then you can use your nail to lift it back out.
The holder should snap snuggly into the tray. It can be lifted out with the tab if needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
