MicroSD-Length Extender & holder

I printed a new enclosure for my A8 board, but the micro sd slot ended up about 1.5 cm deep into the case, and the opening around it is barely big enough to get one finger in. While I could fix it, I decided a length extender was the quickest and easiest fix, since I have had this issue in the past. Moreso... I have a habit of causing small objects to vanish when not looking... so enlarging the size of the micro sd seems beneficial to its continued existance..I couldn't find any size extenders, just port extensions and one full size sd card extender, so I jumped onto Tinkercad and here it is.

This is a rough version, as I just got it functional. The biggest challenge is that only a 2mm area of the card can be attached to anything as the Anet A8 board uses a spring loaded sd slot, and only 2mm sticks out, you actually need just under 2mm in order to get the spring to activate. Right now, the fit is just very tight, with the top bump mostly enclosed, so that tension holds it in, but