Microswiss Ebb42 Mount

I created this simple 42 mm stepper "clip-on" with my lack of skills for an Ender 3 microswiss gantry carriage. I needed something to get the tool board mounted but with the setup of the carriage and the motor mounting to the back of the stepper motor would have sheered off the board and been pointless. With this, I'm able to slip the clip around the motor without it needing to be removed from the carriage to do so.

I included two versions the original which is shown in the images, just print it, mount it, slip it, and make sure the motor has full clearance. The test mount hasn't been tested yet but was just some modifications I made to make it all flow a bit better and should be fine for a typical mount of this board.

Disclaimer: I in no way recommend you use this mount or any model from me. I'm a horrible 3D designer, but hey, it works. If you do avoid this advice, please post a make or comment letting me know how it works.