MidOLED display

This is my design at supporting the many OLED displays for RAMPS boards. This board supports .98" , 1.3", 1.5" and 2.42" OLED displays for Marlin. I have supplied both a Horizontal and Vertical mount/enclosure for each display type so take your pick. The 2.42 supports an SDReader also. Actually the circuit board supports the SDReader but none of the cases support it except the 2.42" ones so if you want to use an SD Reader you will need to design your own case.

If you are using the 2.42" display make sure to configure it to I2C before assembling your display. and solder a jumper across the CS (Chip Select) jumper on the display board. The seven pin header goes in the OLED1 position holes 1-7

I have included the Gerber file in case you want to get your own boards made or for $5 shipped I can send one to you (bare circuit board only) just message me here and I will contact you. I've included several pictures showing the use and a picture of the required cables. The keys on the 8pin