Slicer Discord
Miffy Fidget Spinner – 3D-Druckmodell von MakerWorld MakerWorld
Characters

Miffy Fidget Spinner

2 Downloads
8 Likes
0 Makes
Zum Modell
Requires 3mm ID, 7mm OD, 3mm tall ball bearings to spin. I used these:https://www.amazon.com/uxcell-Bearing-Double-Shielded-Bearings/dp/B07FW18RQY?dib=eyJ2IjoiMSJ9.q1YG1ehkZ4_7kF1JiARYCovsZ2EtB9v_U2V-DvxyaIs-qLcnMP4H3AUtrqCBQ5gvOldu0YhiPu3jbKfaFpUIRDfK_0COqL42gyg0KTYlqO0DBnDloHwv8xgdZMnPmWj4qEw9w93LErJcPSGDX8oXASAXmbhak0Owpf894b1wGz0bwv7X4R3_PWytTfqYWur03huPPt6VssQXTGUww3Pk1eS4bdACGE1YDDXrlP3tJ-Q.3Vwa-88qPuWYP2ipf8IlmEOvYrNt7cNAhqaXMb21EUM&dib_tag=se&keywords=3mm+bearing&qid=1741508934&sr=8-3 Glue the bearing into the center hole carefully to not get glue in the bearing, then insert one of the two pads into the inner bearing hole. Add a tiny bit of glue, then insert the second pad in from the other side. Make sure the pads aren't touching the main body when gluing. If using CA glue, accelerator may be helpful to set the glue before it travels onto the bearing and locks it up.
Kategorie
Characters
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ASA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

4 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen