Milling Machine Organizer

**if STL loads in super small, scale it up 2540%, my cad software does not always play nice for some reason**

An organizer I made to neaten up our small milling machine tools at my job. This organizer is 6" long, ~3.7" tall, and ~2.7" deep. There are 6 holes in the back that are the tap drill size for an M4 thread (for hardware we had on hand), and are on spacing to match a 1"x1" grid, as seems to be found on the pegboard on cheap workbenches. I just tapped the printed holes and screwed it to the pegboard from the backside.


The organizer is made to hold:
1 1/2" edge finder
1 3/8" shank .2" tip edge finder
1 1/2" spot drill
1 3/8" spot drill
1 3/8" shank pointer
A few jaw stops and the allen key for them
A spring loaded tap follower fits on the bottom ledge
The back cubby hole had no specific purpose, but a 3/8" allen key (for Kurt vise jaw bolts) seems to have found a nice place there.