Slicer Discord
Milsbo Latch Extension – 3D-printbaar model van Thingiverse Thingiverse

Milsbo Latch Extension

door caver01
0 Downloads
1 Likes
0 Makes
Model downloaden
This is a simple latch slot extension for the IKEA Milsbo cabinet. It is intended to be used as a “secure” method of propping open the door for ventilation of a greenhouse conversion project.

The Milsbo is excellent for greenhouse conversion. The glass has a very good seal and the doors are constructed in such a way as to provide great surfaces for weatherstripping. Finally, the center gap between the doors can be sealed using a self-adhesive silicone flap made for this purpose.

However, a properly sealed greenhouse can quickly become too humid. On the one had, this is desired, since heat and humidity retention (as well as artificial light) is the whole point of the greenhouse conversion. Yet, it can be helpful to allow periodic venting to keep cyclical humidity under control.

Propping the door open a bit with something works fine, but prying paws can lead to a kitty hazard for your plants. This simple solutions allows you to hang an extension on the latch slot that provides a few a
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

caver01 publiceert ook op

40 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie