Milwaukee Bit Holder

This fits 9 bits for the impact driver bit set which requires 5mm x 2mm magnets or 6mm x 2mm magnets. The best way to print this is where the feet are down with supports on the main part and the fittings as shown in bright green in the pictures. The reason you have to print it this way is to allow it to print the circles, that the magnets fit into, more accurately and precise to ensure the magnets fit nice and tight. It fits right into the holder like it is stock, all you have to do is put one end in and push the other end in until it clicks. The best way to put the magnets in is to put the magnet on the end of long nose pliers and push it into the hole. You can either pressure fit the magnet or glue in place if you want. You can either use a 6mm x 2mm magnet or a 5mm x 2mm magnet, but I would strongly recommend the 6mm x 2mm magnet. The impact driver bit set that I have and the magnets are both linked below.https://www.homedepot.com/p/Milwaukee-SHOCKWAVE-Impact-Duty-Alloy-Steel-Screw-