Milwaukee Bit Holder

Designed for the Milwaukee M18 Impact Drill - M18ONEID

Printed with TPU 100% infill which provides enough rigidity to hold the bits tight but also allows enough flex to not snap the print like I had happening with PETG when removing the bits.

Only 9 grams of TPU per model so will not break the bank. Uses the standard screw that comes on either side of the impact drill and has small lugs to match the indents either side of the screw hole.

I print with the countersunk screw hole facing down and provide 15% support for the hole as it is very easy to pop the support out and this side has the most surface area which allows printing without a raft. No supports provided for any of the bit holes as these print perfectly fine without support.

The fit for the bits is snug as I don't want to loose them when working outside.
You just have to wiggle a bit to release when changing over.

Design will fit either the LHS or RHS depending if you are right or left handed.

For me, I am r