Thingiverse
Minecraft Chest Satchel
von TheDarkHood
33
Downloads
30
Likes
0
Makes
Hey guys! This is a model I created for the iD tech 3d modeling contest. Sadly, it didn't win but that just means I can share it with you guys! The print comes in two pieces, the top and bottom. All you have to do is line up the six holes and put the top on. You may want to glue it down so it stays. There is a joint already built into the top so you can open and close the satchel and holes are on the side for any straps you may want to attach. I cannot print this object as it is to big for my printer so I can't show you how big it is but you may want to enlarge the model as it may be a bit small to wear. I recommend supports but you may be fine without them as most of the model is vertical and has little overhang.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
