Thingiverse
MINECRAFT LEVER LIGHT SWITCH
von bradyallenw
1.4k
Downloads
1.5k
Likes
0
Makes
In Minecraft, a lever is a redstone device that can be placed on various blocks, such as stone, dirt, and wood, to perform various functions. The lever itself is a block that looks like a small switch with a handle on one end.
Instructions: *Only works with older style nubbed switch and not newer flat plate switch*
1. sand and paint
2. remove old switch cover by unscrewing the two screws.
3. replace the old cover with the main box and screw it into place with the original screws
.
4. add a small dot of blue tac into the small hole on the bottom of the lever arm and stick it onto the nub of the switch.
5. make sure the angled faces on the arm close to the hole are facing up and down in order to allow for maximum range of motion.
Instructions: *Only works with older style nubbed switch and not newer flat plate switch*
1. sand and paint
2. remove old switch cover by unscrewing the two screws.
3. replace the old cover with the main box and screw it into place with the original screws
.
4. add a small dot of blue tac into the small hole on the bottom of the lever arm and stick it onto the nub of the switch.
5. make sure the angled faces on the arm close to the hole are facing up and down in order to allow for maximum range of motion.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!