Minecraft minecart

I made this minecart based on the in-game design. All the parts are meant to fit together without glue. Only a zip tie is required.
For the axle, I've used a toothpick.

## Printing details :
Filament : Standard PLA
Printer : Ender 3 stock
All the parts (except for the wheels ) were printed at a 0.2 standard quality (0.2mm) and sliced using the Cura Slicer.
For the wheels, I recommend printing them at Super Quality to preserve the details and to fit perfectly.
It is also recommended to print the under frame using a raft if you have adhesion issues.

After printing, sand down the main frame surface to paint it or use a grey filament if you have it.
If the parts are too tight to fit, try sanding down the edges. This can happen if there first layers are warped or have elephant's footing.

You may also have to shave some part of the toothpick so that the wheel fits perfectly.