Minecraft Pickaxe wall Lamp

Minecraft Pickaxe wall hanger lamp (I was inspired by MaKim, who did sword lamp (amazing work!) Lamp is 60 cm tall, printed in few parts. In addition to the filament, you need an LED strip - Unfortunately, I used the cheapest one and the glue doesn't stick very well, so I had to use some hot glue. (You can use a super glue too) Filament that i used:Sunlu black PLASunlu brown (coffe) PLASunlu white PLA List of printed parts: 1-5 : Main parts6: Pegs for connection main parts7: Covers for LED strips in back side 8: Small pixels - 2x - One fits into the hole at the bottom, the other into the hole at the top9: Pixels for handle 8x - differs from the others because they have a thicker base to allow less light to pass through10: Pixels for top 16x - there are two types, higher and lower, you need 16 of them in total, so you can print however you like. I chose 12 high and 4 low11. Wall hanger mount - two screws attached to the wall, the pick slides into place Assembly : Insert the pins in