MakerWorld
Other Toys & Games
Model downloaden
Mini airplane 2.5
681
Downloads
138
Likes
535
Makes
The wings must be printed in 3 layers, otherwise the plane does not fly well. check it out at BAMBU studioThe first layer must have a height of 0.12, for greater strength. other layers are set to 0.08mm. Carefully remove from the mat so that it does not deform. Bend the rear wings below 90°. There are also elevators at the back, which need to be bent slightly. the ends of the large wings can also be bent, I recommend. Throw the glider up, then it flies far, suitable for years of use even in the wind.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
