Mini Drak Cover

The front cover integrate an O3 Air Unit. There is two version : one for the standard O3 antenna, the other for two TrueRC CORE 5.8 Antenna LHCP. But the antenna supports are too fragile and need redesign. I'm using this antenna with TrueRC X-ai 5.8 LHCP on my goggle 2.

The front hinge is assembled with two 1x15 mm nails.
The cover lock up and down are assembled throw the bridge with 2x8 mm screws. I admit they are a bit tiny.
Front cover and bridge are glued to the foam with the same glue you used to assemble the Mini Drak (UHU poor, goop, E6000)
Canopy handle are glue to cover with cyano

Printed in PETG for best compromise between solidity and flexibility.

For covers
- 0.1 mm layer height
- 1 wall
- 3 top layer
- 2 top layer
- 3% Infill giroïd

Bridge and other parts must be printed solid:
- 0.2 mm layer height, 0.1 mm for screw
- 2 wall
- 4 top layer
- 4 top layer
- 3% Infill giroïd
- Bridge need supports