Thingiverse
Mini Drak Nose Camera Mount
by billyd
65
Downloads
49
Likes
0
Makes
This version splits the mount into a base and cover. The base is glued with goop to the mini drak after cutting off the nose. The cover screws to the base with 3x m2.5 screws (about 10-12mm long is plenty. The hex nuts are captured in the base and should be glued in place to they don't slide away from the hole. I use nylon screws and nuts to minimize weight. Rev B moves the location of the split closer to the rear of the aircraft allowing both cameras to be removed through the front when the cover is unbolted from the base. You no longer need a large hole behind the foxeer camera, just a tunnel for the camera cable into the bay.
This mount is designed for the foxeer 1177 with 2.5 or 2.1mm lens (or any narrower lens will work too) and the runcam2.
The reversed files switch the orientation of the cameras (from the original design shown in the photos Edit: First two photos show the reversed prints as of 4-21-17) and puts the runcam2 on the right side of the plane. This makes it poss
This mount is designed for the foxeer 1177 with 2.5 or 2.1mm lens (or any narrower lens will work too) and the runcam2.
The reversed files switch the orientation of the cameras (from the original design shown in the photos Edit: First two photos show the reversed prints as of 4-21-17) and puts the runcam2 on the right side of the plane. This makes it poss
billyd also publishes on
94 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!