Thingiverse

Mini Drawers Ultimate

by zeropage

15.3k Downloads

10.4k Likes

58 Makes

Go to Model

__What is this thing?__
This is a remix of TrevM's [Mini Drawers](http://www.thingiverse.com/thing:1621667 "Mini Drawers"). The original design is great but I needed some improvements. Thankfully, TrevM provides the *.scad-files, so the required changes could be made using OpenSCAD:

- The runners did not fit perfectly in the slots. I think it depends on your 3D printer how snuggly these pieces fit together. I added a global variable "runnersDiameter" to the corresponding *.scad-files so adjusting the runner's diameters is quiet easy. I was fine with 2.85mm.

- To prevent the drawers from falling out when pulling too far I added a small stopper on the top/front inside of the house.

- Added magnet holes to the house's and drawer's backside. While the aforementioned stopper prevents pulling a drawer too far, the magnets prevent the drawer from sliding when a house is moved or tilted.

- The handles were too delicate for my fingers so I made them oval and increased the

chest of drawers container drawer drawers mini drawers stackable Stackable container stackable house chest of drawers container drawer drawers mini drawers stackable Stackable container stackable house chest of drawers container drawer drawers mini drawers stackable Stackable container stackable house

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format