Mini FPV-Rover Remix

I remixed some of the parts to the Mini FPV rover created by markus_p ...I was having problems getting the tracks to fit so i made the track frames where the front cog can be slid forward or backward at any time needed simply by loosing a M3 bolt that goes thru the center of the cog..I used the remixed tracks from Oleg_Menshikov and adjusted them to fit the cogs i remixed as well as added bevels to the insides so the tracks wont try to run out on the cogs..Only other part needed is a M3 socket head bolt and matching nut, preferably a non-locking nut..
Print the frames at .16 res i used a .4 nozzle ..The tracks print much better at .12 and kind of slow ..The COG also at .16 and the slider shaft as well..

To assemble evenly press the 2 bearings in the front cog then push the slider in the them also space it evenly, they fit snug and should not slip once in place then the cog simply goes in the front with the M3 bolt through the middle of the slider..The rear cog assembles the same a