Mini Fridge_2024

This is revision of my 2018 Mini Fridge.

https://www.thingiverse.com/thing:3229738

At that time, I failed to lower temperature enough.
Even though prototype in woodrock was cool enough, my 3d printed fridge wasn't cool.

In 2024, I challenged to fix problem.

The problems are #1 sealing, #2 cooling.

#1 Sealing

1) Use 28 magnets in door and body, 14 pcs each.
2) Separate fridge body and innerbox and fill the gap(8.5mm) with 5mm and 3mm woodrock.
3) inner box outer walls, covered using aluminum tapes air not to come and go.
4) One more sealing between fridge body and innerbox with glue gun and silicon sealing tape.

#2 Cooling

Peltier has two sides.
One is cold and the other is hot.
Hot side should be cooled off enough. Otherwise cold side temperature goes up again.
So peltier module has heatsink and bigger fan on hot side.
Made lots of vent hole in this hot side fan box.
And it is quite effective and temp goes down lowest -2.4 celsius.

Materials used.