Mini Hygrometer Bracket AMS Lite (angled remix)

Remix of this bracket from A3DMakeureka, which is a great model, but my AMS Lite is on a higher position, so i modified it to allow for a better view, adding an angle, and still can be printed without supports. Original description by the creator:"AMS lite accessory holds the mini rectangular hygrometer/temperature display. It shows the room temperature and moisture for a quick glance/view which is mounted right where the filament spools are located. This bracket can be easily installed in two positions. One being the upper side near 1 and 4, and second towards 2 and 3. The bracket does not interfere with the filament enclosure. This bracket takes in to the account the openings on the sensor casing so that the internal electronics are properly exposed to the atmosphere around and to allow air to pass through. The hygrometer fitting measurements used for this designThe Bracket opening: Length: 45 mmWidth: 26mmHeight: 14 mm Note:The hygrometer used in this design is without the exter