Mini Infill Spool

Recently, the Bambu Reusable Spool was out of stock again, but I urgently needed one for the new filament I had ordered. However, I had some spools with a small amount of filament left on them, and I didn't want to throw that filament away.I found a few other "small" spool designs on Makerworld, but they either required too much filament to print, took a long time to print, or I simply didn't like them... So, I sat down and tried to design my own. I quickly realized that designing "pretty" patterns in Fusion360 was either very difficult or took forever. Then I had the idea to simply use infill as the pattern. And after some experimentation, the MiniInfill Spool was born . It holds approximately 200g of filament, the two halves simply snap onto the cardboard core and it's printed in under 2h! Important: Do not dry the Spools when printed with PLA or PETG, otherwise the spools will melt.Boost MePlease let a Boost here, so i can spend more time into creating ne