Thingiverse
Mini Joystick Housing
von chetjohnston
902
Downloads
833
Likes
11
Makes
This is a two-piece housing for the very inexpensive PS2 joystick modules that you can get on eBay. They are widely available for less than $2 each with free shipping.
This housing is small enough to hide in the palm of your hand if you are controlling a device during a performance.
No wire is shown, however, there is a channel through the parts to route the wire out the end of the housing.
The input to the module is +5VDC. The outputs are X and Y axis 0 to 5VDC proportional analog voltage, and momentary "ON" by clicking straight onto the hat of the joystick. These outputs are very simple to use as Arduino inputs.
This housing is small enough to hide in the palm of your hand if you are controlling a device during a performance.
No wire is shown, however, there is a channel through the parts to route the wire out the end of the housing.
The input to the module is +5VDC. The outputs are X and Y axis 0 to 5VDC proportional analog voltage, and momentary "ON" by clicking straight onto the hat of the joystick. These outputs are very simple to use as Arduino inputs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
