Mini MacPlus Case

You may Need to print with Supports for the Front Piece of the Case.

Each Piece has been Tested and optimized for print speed as best as I could.

The parts you will need for either build are:

The 3.5 Inch 640x480 screen Here is a link to it on Amazon US: https://www.amazon.com/gp/product/B08TBF5PHH/

Here is a link to how to configure it for your PI: https://www.waveshare.com/wiki/3.5inch_DPI_LCD

Regardless of what pi model you use you may need to comment out dtoverlay=vc4-fkms-V3D

You will need A GPIO Cable to connect the LCD Screen you can get that here
https://www.amazon.com/gp/product/B07D991KMR/

Next if you want to used The SD Floppy Mount with an SD Card you will need this Item Here is a link from Amazon https://www.amazon.com/gp/product/B085HLVMP5/

You will need to also get 4MM Tall m3 Threaded inserts To mount everything here is a link to some that I think are good https://www.amazon.com/initeq-M3-0-5-Threaded-Inserts-Printing/dp/B077CL322T/

Any s