Slicer Discord
Mini Magnet Hardware Pickup Tool – Modelo 3D imprimible de MakerWorld MakerWorld
Hand Tools

Mini Magnet Hardware Pickup Tool

9 Descargas
2 Likes
3 Makes
Ver Modelo
Please keep all these small parts away from children and pets, some parts have pointy ends, and they could be a choking hazard too. Make or use these models at your own risk. I liked OpenSourceClassroom's "Magnet Hardware Helper" (https://www.thingiverse.com/thing:1277529), but wanted something simpler and smaller that would fit in my Stanley organizer where I keep my metric hardware (https://www.prusaprinters.org/prints/79702-stanley-014725r-organizer-bin-dividers-with-step-f). This was pretty simple to design in about 5 minutes and it printed in 21 (went with 3 walls and 15% gyroid infill in PETG). I suggest using a brim as well. It works great and I did not need any glue (the ID of the bore is 5.4mm so it will be snug). If it's a bit loose however, you can add a drop of superglue to the end, to help keep it it place. I used a 5x15mm neodymium cylinder magnet but a 5x10mm cylinder magnet may also work. The magnet goes into the tool about 5mm. No supports are needed fo
Categoría
Hand Tools
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
sin soportes · postproceso considerable
Sin soportes Pieza única Tornillería requerida
Soportes 0/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, PETG
Postprocesado
Pegado, Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección