Thingiverse
mini Pekka
door gavinrain
66
Downloads
96
Likes
3
Makes
My take on Clash of Clan's mini PEKKA. There are a few official versions of this, so I kinda did a mix of 3 of them. As you can see from the photo, I did a fairly poor job of painting it!
You will need to print 2x shoulders (pauldrons), 2x bracers to glue onto gloves and 4x brace clips. Glue the bracer on first then glue the clips in afterwards.
I've also provided a sliced version with supports for Elegoo Mars Pro. I got WAY carried away with the supports, so it will definitely not fail, but you'll probably be cutting some stuff off!
I've also included the raw chitubox file so you can add your own supports. I was too lazy to print the base so just stuck the little guy on a piece of failed print... But I've also included a base to print...The mini-Pekka is roughly 6cm high
You will need to print 2x shoulders (pauldrons), 2x bracers to glue onto gloves and 4x brace clips. Glue the bracer on first then glue the clips in afterwards.
I've also provided a sliced version with supports for Elegoo Mars Pro. I got WAY carried away with the supports, so it will definitely not fail, but you'll probably be cutting some stuff off!
I've also included the raw chitubox file so you can add your own supports. I was too lazy to print the base so just stuck the little guy on a piece of failed print... But I've also included a base to print...The mini-Pekka is roughly 6cm high
gavinrain publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
