Mini Portal Gun

Wanted to make a small portal gun, so I started with a 3D model I found at: https://sketchfab.com/3d-models/portal-gun-not-mine-7ec0ac35810848c8b79798d142e568e3n Wanted to make a miniature version, ideally a keychain (may still do this at some point, but the current version is far too fragile for that).I did also want the print to require no glue, but I failed to account for the size of the back of the gun, so the back panel does not fit properly. Spent a good number of hours hacking together a miniaturised version of the portal gun, simplifying the model down to just 5 pieces.I also thickened up the claws a little for strength and added . I used wire cutters to trim off the supports as well as ~1mm from the end of the ‘cables’ that run to the back of the gun. GLUE MAY BE REQUIRED FOR THE ASSEMBLY OF THIS MODELGlue was used to attach the back (white) panel to the body of the gun as well as attaching the ‘cables’ to the back panel. The front panel attached without glue for me, as well a