Mini potatocannon

🥔 BOOM! MINI POTATO CANNON

Bored? Build this! This is a fully functional, 3D-printed combustion cannon that launches potato plugs or BBs using 99% alcohol.

👇READ THE INSTRUCTIONS BELOW!👇

🛑 Hardware Needed (BOM):

1x Stick Lighter / BBQ Lighter: (Crucial! Do not use a standard small lighter. You need the Piezo igniter with the long wires found inside stick lighters).
99% Isopropyl Alcohol (IPA): In a small spray bottle.
Glue: Superglue (CA glue) or Hot Glue.
Tool: A sewing needle.

🛠️ Assembly Instructions:

Disassemble your stick lighter and extract the Piezo ignition mechanism (keep the wires attached!).
Insert the igniter into the slot at the bottom of the printed handle.
The Hot Needle Trick: Heat up a sewing needle and carefully poke two small holes through the plastic into the combustion chamber.
Push the two igniter wires through these holes into the chamber.
Seal the wire entry points and secure the igniter firmly using Superglue or Hot Glue.

🎥 Assemb