Thingiverse
Learning
Zum Modell
Mini Pulse Motor
14
Downloads
21
Likes
0
Makes
This was a fun engineering project to make a very small pulse motor. I included three configurations but it should be noted that configuration three was the one that worked.
You can watch the video of this build here: https://youtu.be/eSzVXSYhLmc
Watch the motor throttling in action here: https://youtu.be/QGNeUsbtkv0
The configuration that worked as you'll see in the video is the third one with the reed relay mounted at an angle.
I used magnets that are 6mm in diameter and 3mm thick. The parts were printed with Autodesk Magenta resin. They were printed on a Draken DLP 3D Printer.
You can watch the video of this build here: https://youtu.be/eSzVXSYhLmc
Watch the motor throttling in action here: https://youtu.be/QGNeUsbtkv0
The configuration that worked as you'll see in the video is the third one with the reed relay mounted at an angle.
I used magnets that are 6mm in diameter and 3mm thick. The parts were printed with Autodesk Magenta resin. They were printed on a Draken DLP 3D Printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
