Mini Quad FPV camera mount

This is a simple FPV Camera mount I designed to sit on top of my build of the [8.5mm H125 Micro Quad](https://www.thingiverse.com/thing:1705383) by @Banana_Science.

The Eachine TX01 NTSC Super Mini AIO 5.8G 40CH 25MW VTX 600TVL 1/4 Cmos FPV Camera's electronic components get hot enough to make PLA soft and deformed. This mount avoids heat issues by clamping down on the neck of the lens.

Print:
- No support needed.
- 2 wall layers.
- 2 top and bottle layers.
- 0.2 resolution.
- 20% infill.

Additional parts:
- 1x 14mm M3 bolts
- 1x M3 nut
- Cable tie

Construct:
1. Put the camera in the clamping hole and hold both sides together.
2. Insert bolt and position the nut into hexagonal hole, screw bolt into nut until both sides are snug together and the camera is clamped into position.
3. Thread the cable tie through the holes under the camera to mount into position on the micro quad.

Here is a [video of the first successful flight](https://www.youtube.com/watch?v