Mini Robot Figurine

My take on Gareth Davies' "Mobile Media" sketch. The print is two parts, connected by a single M5 screw. All the parts needed are linked below, printed with default settings on an Elegoo MARS SLA printer. A Formlabs or AnyCubic printer should be fine too. No supports, no raft, just printed directly on the print bed. I threaded the hole with an M5 screw while it was still soft. Be careful and use a sharp spatula to remove the leg assembly from the print bed, as the part is very fragile.

Parts & Equipment:
AnyCubic Grey 405nm Rapid Resin: https://amzn.to/2TJGDg9
Elegoo MARS SLA printer: https://amzn.to/2YX5PWi
(Alternative Printer: AnyCubic Photon: https://amzn.to/2Z1PFLv)
UV Curing Lamp: https://amzn.to/2ZaAJ92
Swan 99% Isopropyl Alcohol: https://amzn.to/2Z40k8g
M5 x 10mm Screw (1 needed): https://amzn.to/31PEAdo

Gareth Davies' original sketch: https://twitter.com/Spudonkey/status/1160226294078087168