Slicer Discord
Mini Screwdriver With Optional Magnet – 3D-Druckmodell von MakerWorld MakerWorld
Hand Tools

Mini Screwdriver With Optional Magnet

320 Downloads
45 Likes
153 Makes
Zum Modell
Magnetic Mini screwdriver I designed in Tinkercad. It has an optional hole in handle to fit an 8mm x 2mm magnet inside and help hold screws. The magnet may have a tight fit but you can use a something solid to press it in once you get it started, then you can insert the plug which also may seem a bit tight but once you get it started you can press that end against a table or something solid and it should seat flush once it hits the magnet. My Settings: .20 layers, 20% adaptive cubic with combination infill (checked), 5 bottom and top shells Support: I didnt need support or brims as I am fortunate to have the Biqu frostbite/glacier plates (love these and highly recommend) but if you dont have them or a sliceworx type plate, you may want to add a 5-10 mm outer brim to help stabilize them and/or supports, just use your best judgement on if you need them or not.
Kategorie
Hand Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

ssweat veröffentlicht auch auf

10 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen